Filter
Top Products
4-2
REMOVING THE OVEN CONTROL/DISPLAY BOARDS,
AND THE TOUCH PANEL ASSEMBLY
1. Disconnect the electrical power to the
oven.
2. Open the oven door.
3. Remove the bottom screw from each of
the two side trim pieces (see below).
4. To remove the side trim, pull the bottom
out approximately 2˝, and slide the top
down to free it from the control panel.
CAUTION: When you work on the built-in
oven, be careful when handling the sheet metal
parts. Sharp edges may be present, and you
can cut yourself if you are not careful.
6. To remove the oven control panel, pull it
out at the bottom, and lift and unhook it
from the oven cabinet support at the top.
7. Disconnect the wire connectors from the
control board and set the panel assembly
face down on a padded surface to protect
the finish.
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so could result in death or
electrical shock.
WARNING
5 Wire Connectors
5. Remove the screws from the oven control
panel.
Control
Panel
Screw
Oven
Control
Panel
Lift Off
Top
Support
Side Trim Screw
(1 On Each Side)
Pull Out Bottom
Of Side Trim
Pull Side Trim
Down & Away
From Control
Panel