Miele 10 228 830 Microwave Oven User Manual


 
,
Repairs to this appliance must
only be carried out by a Miele
authorised service technician in
strict accordance with current local
and national safety regulations.
Repairs and other work by
unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
Some minor problems can be corrected
without contacting Miele.
What to do if...
...aprogramme will not start.
Check whether,
^ the appliance door is closed
properly.
^ the system lock has been activated
(see "System lock").
^
the word "door" has appeared in the
display. The door has remained
closed for 20 minutes or longer (see
"door" message").
^
the appliance is plugged into the
mains supply and switched on at the
socket.
^
the mains fuse has tripped. If it has,
there could be a fault with the
appliance, the household electricity
supply or another appliance
(disconnect the appliance from the
mains supply and contact a qualified
electrician or the Miele Service
Department, see "After sales
service").
. . . a noise can be heard after a
cooking programme.
This is not a fault.
The cooling fan will continue to run for a
while after the oven has been switched
off to dispel any moisture from the oven
and prevent it settling on the control
panel or surrounding furniture.
It will switch off automatically.
. . . the display does not light up.
Check whether,
^
the time of day display has been
switched off (press and hold the m
button for a few seconds).
^ the time of day display has been
programmed to switch off at night.
. . . the turntable does not turn
smoothly.
^ Check whether the area underneath
the turntable is clean.
^
Check whether the contact area
between the turntable and the locator
is clean.
Remove any soiling.
. . . food is not adequately defrosted,
heated or cooked at the end of the
selected cooking duration.
^
Check whether the correct power
level was selected for the duration
set.
The lower the power level, the longer
the duration required.
^
Check whether the programme has
been interrupted and not restarted.
Problem solving guide
68