Filter
Top Products
2. Niche height 360 mm
^
Remove all the accessories including
the turntable and the roller ring from
the microwave oven cavity.
^
Place the microwave on is right-hand
side so that the front frame
overhangs the front of the table or the
work surface.
^
Unscrew the three feet under the
microwave oven and replace them
with the three longer feet using the
same screws.
^
Screw the spacer disk from the
accessory pack into the hole on the
underside of the appliance where the
cable is attached using the short
screw supplied.
^ Draw a line on both sides of the
housing unit 347 mm above the floor
of the housing unit.
^ Now proceed as described in
"1. Niche height 350 mm".
Installation
77