Filter
Top Products
1. Niche height 350 mm
^
Draw a line on both sides of the
housing unit 337 mm above the floor
of the housing unit.
^
Position the lower edge of the spacer
on this line and align the stopper at
the front of the spacer with the front
of the housing unit side wall.
^ To secure the spacers and hooks,
place a screw in one of the front two
holes and another in the middle of
the long hole at the back.
The long hole allows for adjustment if
necessary, and the two additional
holes are in case additional screws
are required.
^
Slide the appliance into the housing
unit, and pull the cable with the plug*
through the back of the unit.
^
Secure the appliance at the front by
lifting it over the hooks and lowering it
into position.
^
Check that the appliance is secure
by pushing lightly on the upper edge
of the front frame.
^
Check that it is correctly aligned.
^
Connect the appliance to the
electricity supply.
* Plug shown is for illustration purposes.
Installation
76