Filter
Top Products
19
Model H63 Operat ing Procedures
Step 2
Install the beater assembly. First check scraper blades
for any nick s or signs of wear . If any nicks are present,
replace both blades.
If blades are ingood condition, installthe scraper blade
clips on the scraper blades. Place the rear scraper
blade ov er t he rear holding pin on the beat er.
Figure 3
Note: The hole on the scraper blade must fit securely
over the pin to prevent costly damage.
Hold the rear blade on the beater and slide it halfway
into the freezing cylinder . Install the front scraper blade
over the front holding pin. Slide the beater assembly
completely into t he fr eezing cylinder .
Figure 4
Make sure t he beater as sembly is in position over the
drive shaft. Turn the beater slightly to be certain that
the beater is properly seated. When in position, the
beater will notprotrude beyond the front of the freezing
cylinder.
Figure 5
Step 3
Install the torque rotor a ssembly. Assemble the torque
rotor b y sliding the two o--r ings on the fr ont of the shaft
and lubricate them thoroughly to prevent leaking.
Place the white plastic guide bearing on the rear of the
rotor shaft. DO NOT lubricate plastic guide bearing.
Figure 6
Insert the tor que rotor , plastic guide bearing end first,
making sure that it fits into the hole in the beater drive
shaft. Rotate it several tim es to check for proper
positioning.
Figure 7