Taylor 048887-M Blender User Manual


 
Model H63 Table of Contents
Table of Contents
Section 1 To the In staller 1............................................
Installer Safety 1........................................................
Site Preparation 1.......................................................
Air Cooled Units 2.......................................................
Water Connections (Water Cooled Units Only) 2............................
Electrical Connections 2.................................................
Beater Rotation 3.......................................................
Refrigerant 3...........................................................
Section 2 To the Operator 4...........................................
Section 3 Safety 5....................................................
Section 4 Operator Parts Identification 7...............................
Accessories 9..........................................................
Section 5 Important: To the Operator 10.................................
Symbol Definitions 10....................................................
Power Switch 10.........................................................
Liquid Crystal Display 11..................................................
Consistency Control 11...................................................
Product Ready Light 11...................................................
Reset Mechanism 11.....................................................
Operating Screen Descriptions 11..........................................
Operator Menu 14.......................................................
Section 6 Operating Procedures 18.....................................
Assembly 18............................................................
Sanitizing 22............................................................
Priming 23..............................................................
Daily Closing Procedures 24..............................................
Daily Opening Procedures 25..............................................