Filter
Top Products
35
Model H63 Troubleshooting Guide
PROBLEM PROBABLE CAUSE REMEDY
PAGE
REF.
12. No freezer operation after
placing unit in the AUTO
mode.
a. Unit unplugged. a. Plug into wall recept acle. -- -- --
b. Circ uit breaker off or
blown fuse.
b. Turn circuit breaker on or
replace fuse.
-- -- --
c. Beater motor out on reset. c. Clear t he tone and r eset
freezer.
11
d. Compressor o f f on high
pressure cut out.
d. Clear the tone. Place unit
in the AUTO mode. If
problem persists, contact
service technician.
15
e. Water turned of f
(water-cooled units.)
e. Re-establish w ater supply. -- -- --
13. Liquid Crystal Display is
blank after power switch is
placed in the ON posit ion.
a. Unit unplugged. a. Plug into wall recept acle. -- -- --
b. Circ uit breaker off or
blown fuse.
b. Turn circuit breaker on or
replace fuse.
-- -- --
c. Screen intensity out of
adjustment.
c. Call service technician to
adjust.
-- -- --
14. Product not feeding into
freezing cylinder.
a. Inadequate mix in hopper. a. Fill hopper with m ix. 23
b. Mix inlet hole frozen up. b. Hopper temperature
needs adjustment. Call
service technician.
-- -- --
c. Assembled air tubes
installed incorrectly.
c. Install in mix inlet hole,
using end with the hole in
it. Pin on inner air t ube
must be pos itioned at the
bottom of t he notc h in the
outer air tube.
23