Filter
Top Products
24
Models H62 & H63Operating Procedures
Step 7
Slide the two o--r ings onto the draw valve and
lubricate.
Figure 13
Step 8
Lubricate the inside of the door spout, top and bottom.
Insert the draw valve into the freezer door from the top.
It will be necessary to rotate the draw valve bracket to
the right to allow installation of door on freezer.
Figure 14
Step 9
Place the o--ring on the prime plug and lubricate.
Figure 15
Step 10
Screw the prime plug into position on the front of the
door.
Step 11
Place the large rubber gasket into the groove on the
back side of the freezer door. Slide the white plastic
front bearing onto the bearing hub. Make certain that
the flanged end of the bearing is resting against the
freezer door. DO NOT lubricate the gasket or the front
bearing.
Figure 16