25
Models H62 & H63 Operating Procedures
Step 12
Install the freezer door. Locate the torque rotor in the
center hole of the freezer door. Position the door on the
four studs on the front of the freezing cylinder and
firmly push it into place. Install the four handscrews on
the studs and finger--tighten equally in a criss--cross
pattern to insure the door is snug. Do not
over--tighten.
Figure 17
Step 13
Rotate the draw valve bracket to the left to engage the
draw arm.
Step 14
Install the drip pan into the hole in the front panel.
Figure 18
Step 15
Install the torque arm. Position the torque arm by
slipping it up through the slot in the operating arm and
then down into the hole in the torque rotor shaft. Check
the torque arm by moving it back and forth to be sure
it moves freely and easily.
Figure 19
Step 16
Install the front drip tray and splash shield.
Figure 20