Filter
Top Products
17
Model 8756 Operating Procedures
Step 2
Install the drive shaft through the rear shell bearing
in the freezing cylinder and engage the hex end
firmly into the gear box coupling. Be sure the drive
shaft fits into the drive coupling without binding.
Figure 8
Step 3
Check the scraper blades for any nicks or signs of
wear. If any nicks are present, replace both blades.
If the blades are in good condition, install the
scraper blade clips on the scraper blades. Place the
rear scraper blade over the rear holding pin on the
beater.
Figure 9
Note: The hole on the scraper blade must fit
securely over the pin to prevent costly damage.
Step 4
Holding the rear blade on the beater, slide it into the
freezing cylinder half way. Install the front scraper
blade over the front holding pin.
Figure 10
Step 5
Install the beater shoes. Slide the beater assembly
the rest of the way into the freezing cylinder.
Figure 11
Make sure the beater assembly is in position over
the drive shaft. Turn the beater slightly to be certain
that the beater is properly seated. When in position,
the beater will not protrude beyond the front of the
freezing cylinder.
Repeat these steps for the other side of the
freezer.