Filter
Top Products
30
Model 8756Operating Procedures
Draining Product From the
Freezing Cylinder
Step 1
Press the AUTO and MIX REF keys to cancel
freezer operation.
Step 2
Open the mix cabinet door and remove the mix
storage cover, the mix tank cover, the mix tank, and
the mix probe.
Step 3
If local health codes permit the use of rerun,
empty the mix from the mix tank into a sanitized,
NSF approved stainless steel rerun container. Place
a sanitized lid on the rerun container and place i t in
the walk-in cooler.
Note: If local health codes DO NOT permit the
use of rerun, the product must be discarded.
Step 4
Placethesuctionlineinanemptypailinthemix
cabinet.
Repeat these steps for the second freezing
cylinder.
ALWAYS FOLLOW LOCAL HEALTH CODES.
Rinsing
Step 1
Fill the empty pail in the mix cabinet with two gallons
(7.6 liters) of cool, clean water. Place the free end
of the suction line in the pail of water.
Step 2
Disconnect the pressure line from the pressure
switch and place it in the pail of water.
Step 3
Press the PUMP key. This action will cause the
rinse water to be pumped through the a ir/mix pump
and out through the pressure line. After
approximately 1 5 seconds, press the PUMP key to
stop operation.
Figure 61
Step 4
Drain and connect the free end of the pressure line
to the pressure switch.