Filter
Top Products
27
Model 8756 Operating Procedures
Step 12
When a steady stream of sanitizing solution is
flowing from the prime plug hole in the bottom of the
freezer door, press the PUMP key. This will
de-activate pump operation. Push down the prime
plug and allow the beater to agitate for 5 minutes.
Figure 51
Step 13
After 5 minutes, open the prime plug. Press the
PUMP key. Open the d raw valve and draw off the
remaining sanitizer. Momentarily open the center
draw handle to sanitize the center door spout.
Figure 52
Step 14
When the sanitizer stops flowing from the door
spout, close the draw valve. Press the WASH and
PUMP keys to stop operation.
Figure 53
Step 15
Disconnect the pressure line from the pressure
switch. Drain the sanitizer. Reconnect the pressure
line to the pressure switch.
Repeat these steps for the second freezing
cylinder.
Step 16
Prepare a sink with an approved sanitizing solution
(examples: Stera SheenR or Kay-5R). USE WARM
WATER AND FOLLOW THE MANUFACTURER'S
SPECIFICATIONS.
Step 17
Take the following parts to the sink and sanitize:
mix tanks, mix tank covers, mix probes, mix storage
covers, and funnels.