Filter
Top Products
23
Model 8756 Operating Procedures
Step 8
Slide the o-ring into the groove o n the mix inlet fitting
and lubricate the o-ring.
Figure 34
Step 9
Insert the mix inlet fitting into the hole in the base of
the liquid valve body.
Figure 35
Step 10
Secure the pump parts in position by sliding the
keeper pin through the holes located at the bottom
of the pump body.
Figure 36
Step 11
Assemble the flare line and suction line. Attach the
suction line to the barbed end of the mix inlet fitting
and allow the weighted end to hang freely.
Attach one end of the flare line to the threaded fitting
on the lower side of the pump body. Allow the other
end to hang freely.
Figure 37