Filter
Top Products
18
Model 8756Operating Procedures
Step 6
Place the large rubber gaskets in the grooves on the
back side of the freezer door.
Figure 12
Step 7
Slide the white plastic front bearings over the baffle
rods. Make certain that the flanged end of the
bearing is resting against the freezer door. DO NOT
lubricate the gaskets or the front bearings.
Figure 13
Step 8
Slide the o-rings into the grooves on the prime
plugs. Apply an even coat of lubricant to the o-rings
and the shafts.
Figure 14
Step 9
Insert the prime plugs into the holes at the top of the
freezer door and push down.
Figure 15
Step 10
Insert the baffle rods through the beaters in the
freezing cylinders.
Figure 16