Filter
Top Products
Built-in DM Oven Care and Use Manual
CAUTIONS:
To prevent personal injury:
• Before replacing the light bulb, be sure the electric
power is turned off at the circuit breaker.
• Halogen bulbs get HOT INSTANTLY when turned ON.
• Be sure the oven and light bulb are cool.
• Do not operate the oven unless the light cover is
securely in position.
53
Do-It-Yourself Maintenance
Do-It-Yourself Maintenance
Replacing the Oven Light
Replace bulb with a 12-Volt, 10-Watt Halogen bulb only.
To replace Halogen Bulb:
1. Turn off circuit breaker.
2. Remove oven racks.
3. Slide the tip of a table knife blade between the fixing clip and
the glass lens cover.
5 Gently twist the knife blade to loosen the glass lens cover.
Catch lens cover with other hand as it loosens. Set aside.
6. Remove the fixing clip.
7 Remove the bulb by grasping and sliding the bulb straight up
until the two prongs have cleared the ceramic holder.
8. Do not touch the glass of the new replacement bulb with your
fingers. It will cause the bulb to fail when it first lights. Grasp
the replacement bulb with a clean paper towel or facial tissue
with the prongs facing down. Place the two prongs in the ceramic
holder, pressing gently until the two prongs locate in the ceramic
socket.
9. Press down gently to seat the bulb.
CAUTION: If the light cover is damaged or broken, do not
use the oven until properly repaired.
The oven lights have a removable lens cover and a halogen light
bulb. The ceramic light socket housing is not removable.
10W HALOGEN
LAMP
Fixing
Clip
Housing
Ceramic Holder
Holder Clip
Lens
The oven has been preset to a 12- hour clock format.
To change the Time-of-Day Clock to a 24-Hour Clock, follow
these steps:
1. Turn off both ovens.
2. Touch START and hold the CLOCK pad at the same time.
3. 12H appears in the Clock window; release both pads at the
same time.
4. Touch CLOCK and 24H replaces 12H. This alternates when
CLOCK is touched.
5. To complete the change, touch START.
Changing to the 24-Hour Clock
Format
10. Place the fixing clip on the lens cover.
11. Slide the protective lens into the holder clip and push the other
end until the fixing clip snaps back into the housing.
12. Turn on circuit breaker.
NOTE: The Upper or Single Oven Light must
be replaced by a qualified service tech-
nician.