Built-in DM Oven Care and Use Manual
The numbers were touched too rapidly. Be sure you remove your finger from the first
number pad before touching the next digit.
Touch
OVEN OFF
or turn power off at the circuit breaker, wait 3 minutes and turn
the oven back on. If condition persists, note the code number and call an authorized
service technician.
This is caused by
close
contact
to
the
control
panel
for
more
than
60
seconds, (i.e.;
someone
leaning
against
the
controls
or
objects
hanging
in
front
of controls). Follow
guidelines for "F followed by 2 digits", above.
Oven is in Sabbath mode. To turn off sabbath, touch OVEN OFF.
This is normal. The fan turns off automatically when the electronic components have
cooled sufficiently.
Make sure there is proper electrical power to the oven. See the Clock and Timer
sections on Pages 9 and 10.
Make sure there is proper electrical power to the oven. Check the circuit breaker or
fuse box to your house.
Replace or reinsert the light bulb if loose or broken. See Page
53
. Touching the bulb
with your fingers may cause the bulb to burn out quickly. Oven light does not work if
Self Clean mode is set. Oven light cannot be turned on or off while
sabbath mode is in operation.
Try suggestions in "Solving Baking Problems, page 55. Adjust oven thermostat.
See Calibrating Oven Temperature in Do-It-Yourself Maintenance, Page
54.
Verify that self clean mode was properly programmed. See "Self Clean Mode
Operation, page 49). The oven temperature is too high to set the self clean
operation. Allow the oven to cool to room temperature and reset the controls.
This is normal during and after self clean. Allow the oven to cool below the locking
temperature.
Heavily soiled ovens may require a second self clean for a longer period of time.
Heavy spillovers should be cleaned before starting the clean cycle. See Before You
Self Clean, Page
48.
Do not run Self Clean. Call for service. See Page
54.
Extendable Rack was left in oven during self clean. Apply a small amount of vegetable oil to
the rack support areas to facilitate rack extension and removal. Color change is
permanent. To order a replacement Extendable Rack, phone Thermador Customer
Support at (800) 735-4328.
56
Problem Solving / Consumer Service
Solving Operational Problems
Before calling for service, check the following to avoid unnecessary service charges.
PROBLEM POTENTIAL CAUSES AND SOLUTIONS
OVEN
All the numbers touched do not
appear in display
F followed by 2 digits appears in
the display window
F-24 or F-25 appears in
display window
S
A
b
appears in display window
Cooling fan continues to run after
oven is turned off
Clock and timer do not work
Oven will not work
Oven light does not work
Food is overdone or underdone
Oven will not self clean
Oven door will not unlock
Oven does not lock in Self
Clean mode
Oven Racks does not glide or
extendable rack is difficult to
extend. Racks are discolored.
Oven is not clean afeter the
clean cycle