Filter
Top Products
-
.
m
Display messages
Messages will appear on the display to guide you
with your cooking. If you attempt to enter
unacceptable instructions, “Err” will appear on the
Display. Touch OFF/CANCEL and re-enter the
instructions.
Audible signals
Audible signals are available to guide you when
setting and using your oven. A programming tone
will sound each time you touch a pad. Two tones
will sound between cycles. Three tones signal the
.
end of a Cook or Defrost cycle. If you do not hear
a tone, it is because of incorrectly entered
instructions.
Setting the clock
When the oven is first plugged in, a tone sounds
and the Display shows “12:OOoo”. If the electric
power ever goes off, the Display will again show
“12:OOoo” when the power comes back on.
You can cook without setting the clock, but the
Display will show “12:OOoo” (plus the hours,
minutes and seconds that have elapsed since the
oven was plugged in).
1. To set the clock, touch CLOCK. The Display
will show “12:OOoo” (if time of day has not been
set before) or the time previously set. The
colon will disappear.
2. Touch Number Pads for the correct time of
day. The Display will show what numbers you
touched in the order you touched them. This
example shows 3:25.
3. Touch CLOCK. The colon will appear without
blinking and the seconds (in small display on
the right) count up. The Clock is set.
If you have touched in an incorrect time,
such as 12:65, “Err” will show on the Display.
Touch CLOCK and start over.
NOTE: To reset the clock, touch CLOCK. The
current time will show on the Display and the
colon will disappear. Continue to set the clock as
shown above.
Using OFF/CANCEL
Touch OFF/CANCEL to:
. Erase instructions if you make a mistake during
programming.
l
Cancel the Minute Timer.
l
Stop the oven temporarily during cooking.
NOTE: The oven may also be stopped during a
cycle by opening the door. Close the door and
touch START/ENTER to restart.
11