Filter
Top Products
Setting Up
12
PSR-K1 Owner’s Manual
Inserting the SmartMedia card
BEFORE you turn on the power of this instrument,
make sure to properly insert the included SmartMe
-
dia card in the card slot on the rear panel.
With the gold-plated contact side facing down, insert the
SmartMedia card firmly but carefully into the card slot, as far
as it will go. Be careful not to insert the card upside down or
back side in.
* This instrument uses SmartMedia™ (3.3V) memory cards.
By inserting the SmartMedia card beforehand, you have
access to the SmartMedia card songs, as well as your custom
backup settings, including those of the panel controls, Regis
-
tration Memory, and User songs. (See page 52, 84.)
Make sure to read the section “Using SmartMe-
dia™ cards (memory cards)” on page 11 for more
important information on the SmartMedia card.
Setting up the included microphone
Also included with the instrument is a microphone,
letting you enjoy karaoke sing-alongs while playing
back the songs, or for singing and playing at the
same time.
■ Connecting the microphone
Before turning on the power of this instrument, connect the
plug of the included microphone to the MIC jack on the rear
panel.
■ Moving the Microphone Holder
The microphone holder can be installed on either side of the
instrument. If you remove the holder, put the spare micro
-
phone holder cap in the hole.
• Use your SmartMedia card! If you use the instrument without
it, all settings and recordings you make—User songs, panel
settings, and Registration Memory—are all lost when you
turn off the power.
• Be careful not to insert or pull out the SmartMedia card while
the power is turned on. Doing so may result in damage to the
SmartMedia card and the internal data. Make sure to insert
and pull out the SmartMedia card only when the power is off.
M
IC
OUTPUT
P
H
O
N
E
S
D
C
+
-
IN
1
2
V
R
L
• To avoid loud pops and sudden noise, turn the volume of the micro-
phone all the way down by turning the [MIC VOLUME] control to
the left. Also, set the microphone switch to OFF.
• Use the cable holder next to the MIC jack to securely fasten the
cable and prevent the plug from being inadvertently pulled out.
ON
OFF
DYNAMIC
M
I
C
O
U
TPU
T
P
H
O
N
E
S
D
C
+
-
IN
1
2
V
R
L
Cable holder
NOTE
Microphone
holder
Microphone holder cap