X16 User Guide
- 34 -
Features
Handset/Headset Volume Control
The volume of the handset and headset can be adjusted to compensate for
hearing levels. Press the volume+ to increase or the volume- to decrease the
volume of the active status of the endpoint. For example, while speaking on the
handset, the volume keys will adjust the handset volume.
Headset Activation
Each digital telephone endpoint comes with a 1/8 inch (2.55 mm) standard
“cellular” style telephone headset jack, which can be activated by dialing the
feature code
Feature
+9. This feature code can be programmed on a button,
so that headset can be enabled and disabled as needed. In addition, a headset
must be plugged in to enable headset mode.
Note:
The voice quality and performance of headsets may vary
.
Hold
Extension users may place Telephone Company central office line calls on hold
allowing them to be picked up at other extensions.
Hot Dial Pad
Hot dial pad allows extension users to dial numbers without lifting the handset or
pressing the speaker button.
Intercom Calling
Each extension is assigned a unique three digit code (number) ranging from 301
to 399. The number used as the time of registration becomes that extension’s
intercom number. Dial the three digit code to intercom another extension.
DSS/BLF buttons allows for one touch intercom calling.
Intercom Paging
Intercom paging is similar to intercom calling, but when the call is connected, the
called party’s mute button is active. This allows the called party to have private
conversations without being overheard.
Line Status Detection (Line in Use)
From Idle to Busy
– The system will detect if another device is using one of the
telephone Lines and will automatically identify the line as busy.
From Busy to Idle
– The system will detect when the line is no longer busy, and
automatically identify the line as idle.
-
19 -
Programming
Programming
The system has two areas of programming; Phone (extension) and System.
The Phone programming parameters will only affect the extension that is
doing the programming; whereas, the system programming parameters
affect the whole system.
From an Idle telephone press the program button
Press the center navigation key to select “Phone Setup” and then scroll
through the phone programming.
Extension parameters such as voicemail will remain for up to 120 seconds
when an extension is unplugged or being relocated. To relocate an
extension simply unplug it and plug it into another extension port.
Note: Extension will appear busy to all other extensions when they are in Programming or
reviewing caller ID.
Pro
ram Button
01:16A 12/10 SUN
301
Æ Phone Setup
System Setup
Select
