X16 User Guide
- 6 -
Notices
Notices
Hearing Aid Compatibility:
The digital telephone endpoints are hearing aid compatible, as defined in section
68.316 of Part 68 FCC Rules and Regulations.
UL/CSA Safety Compliance:
The X16 system has met all safety requires, and found to be in compliance with
the Underwriters Laboratories (UL) 60950-1.
Warning: This service information is designed for experienced repair technicians
only and is not designed for use by the general public. It does not contain
warnings or cautions to advise non-technical individuals of potential dangers in
attempting to service a product. Products powered by electricity should be
serviced or repaired only by experienced professional technicians. Any attempt to
service or repair the product or products dealt with in this service information by
anyone else could result in serious injury or death.
This equipment generates, uses, and can radiate radio frequency energy, and
if not installed and used properly, that is, in strict accordance with the
instruction manual, may cause interference to radio and television reception.
This equipment has been tested and found to comply with the limits for a
Class B computing device in Subject J of Part 15 of FCC Rules, which are
designed to provide reasonable protection against such interference.
However, there is no guarantee, or warranty, that interference will not occur
in a particular installation. If this equipment causes interference or fails to
operate correctly, due to radio frequency interference (RFI) or
electromagnetic interference (EMI), it will be fixed at the owners’ expense.
FCC Information
Provide the Telephone Company with the following FCC Information:
Item Specification
FCC Registration D6XKH05BX16
Ringer Equivalence 0.5B
Networks Address Signaling E
Required Network Interface RJ11 & RJ14
-
47 -
Voice Mail
Use the up or down navigation buttons to scroll through the programming
choices, Press the center navigation button to select the “VoiceMail Setup”
parameter.
Use the up or down navigation buttons to scroll through the programming
choices, Press the center navigation button to select the “Personal OGM”
parameter.
Press the center navigation button to select “Play” to listen to the current
message.
To change the message use the down navigation button to scroll to
”Re-Record“ and press the center navigation button, and lift the handset to
begin recording.
Press the center navigation button again to “Stop” the recording, and preview
the newly recorded message.
Hang up the handset to accept the new message or select “Re-Record” to
rerecord the Outgoing Message.
AUTO MUTE
ÆPersonal OGM
Clear My VMSG
