Filter
Top Products
23
Operation (Continued)
Notes:
1. Box drive motors are designed to run at a moderate temperature of 40° C [104° F]. In some cases they
may feel hot to the touch.
2. Adjustment of the machine or taping heads are described in the "Adjustment" section of this manual.
CAUTION – If drive belts are allowed to
slip on box, excessive belt wear will
occur.
Figure 3-13 – Box Size Set-Up
Box Sealing
WARNINGS
1. Remove tools or other objects from machine bed before starting machine.
2. Keep hands and loose clothing away from moving belts, flap kicker and flap kicker cam.
3. When feeding boxes to the machine by hand, push box in from end only – DO NOT PUSH
WITH HANDS ON ANY CORNER OF THE BOX.
5. Never attempt to remove jammed boxes from the machine while machine is running.
See "Box Jams", page 24.
1. Connect electrical and air supplies.
2. Turn main air valve "On" and adjust air regulator if pressure does not read 5 bar gauge pressure [70 PSIG].
3. Press electrical "On" button to start drive belts.
4. Continually feed boxes to case sealer, case sealer will automatically space entrance of boxes to machine.
5. Turn electrical and air supplies "Off" when machine is not in use.
6. Reload and thread tape as necessary.
7. Be sure machine is cleaned and lubricated according to recommendations in "Maintenance" section of this
manual.
Figure 3-13
If the box is hard to move under the top head or is
crushed, raise the top head slightly.
If the box movement is jerky or stops under the top
head, move the side drive belts in slightly to add
more pressure between the box and drive belts.
Note: Upper head has unique feature for
overstuffed boxes. The head will raise up to
13 mm [1/2 inch] to compensate for this type of
condition.