Filter
Top Products
30
Figure 5-2 – Upper Taping Head Leveling
Adjustments (Continued)
Upper Taping Head Leveling
If the upper taping head is not horizontal, it can be leveled by adjusting the self-locking nut.
1. Loosen the five bolts on each side of crossbar shown in Figure 5-2A.
2. Remove access cover as shown in Figure 5-2B and (using M13 hex key wrench) tighten or loosen M8
self-locking nut until upper head is level.
3. Take measurement from exit end of upper head assembly and front of flap folding ski to machine bed, as
shown in Figure 5-2. Upper assembly must be level ±1.5 mm [±1/16 inch].
4. Retighten five bolts on each side of crossbar to secure adjustment.
WARNING – Turn air and electrical supplies off and disconnect before beginning adjustments.
Failure to comply with this warning could result in severe personal injury or equipment
damage.