Filter
Top Products
31
Adjustments (Continued)
Gate Pressure Regulator
Figure 5-3
The gate air pressure is controlled by a regulator
mounted under the machine frame. This provides
adjustment of the gate lifting force. When light
weight boxes are being run the gate pressure can
be reduced to minimize lifting of the box.
Gate Stroke Setting
Figure 5-4
The machine is initially set at the maximum gate lift
of 25 mm [1 inch]. However this can be reduced if
needed for special situations. To do this, remove
the center roller section and turn the stop nuts
clockwise until the desired lift is achieved.
Figure 5-3 – Gate Pressure Regulator
Figure 5-4 – Gate Stroke Setting
WARNING – Turn air and electrical
supplies off and disconnect before
beginning adjustments. Failure to comply
with this warning could result in severe
personal injury or equipment damage.