Filter
Top Products
280
Error Messages
GPIB Messages
Execution Errors
These are error messages in the range -200 to -299. They indicate
that an execution error has been detected by the execution control
block.
An execution error is signaled by the execution error bit (bit 4) in
the event status register.
-200 Execution error
This indicates that an execution error has occurred but the control
block cannot be more specific.
-201 Invalid while in local
This command is invalid because it conflicts with the configuration
under local control.
-202 Settings lost due to rtl
A local setting was lost when the instrument was changing from
remote to local control, or from local to remote control.
-220 Parameter error
This indicates that a parameter error has occurred but the control
block cannot be more specific.
-221 Settings conflict
A valid parameter was received, but could not be used during
execution because of a conflict with the current state of the
instrument.
-222 Data out of range
The data, though valid, was outside the range allowed by the
instrument.