Filter
Top Products
71
Setting Up the System
Setting the Display Brightness
Deselecting the Through-Power Mode
When you switch the through-power mode off, the last set
calibration factor becomes active, and the attenuation factor is set
so that the filter attenuation does not change.
1. Press S
YST repeatedly until THRUPOWR is shown at the bottom
of the display.
2. Select OFF to switch off the through-power mode.
Resetting the Through-Power Mode
To reset THRUPOWR, press and hold SYST until the value resets
(this takes approximately two seconds).
THRUPOWR resets to OFF.
5.4 Setting the Display Brightness
This parameter sets the brightness of the display. To set the
brightness,
1. Press SYST repeatedly until BRIGHT is shown at the bottom of
the display.
2. Use Modify keys to set the brightness.
Resetting the Display Brightness
To reset BRIGHT, press and hold SYST until the value resets (this
takes approximately two seconds).
BRIGHT resets to full brightness.