Breville BBM100 Bread Maker User Manual


 
5
Breville recommends safety first continued
Always ensure the kneading blade is removed
from the base of the baked loaf prior to
slicing.
Keep the inside and outside of the appliance
clean. Follow the cleaning instructions
provided in this book.
IMPORTANT SAFEGUARDS FOR ALL ELECTRICAL APPLIANCES
STEAM VENTS ARE VERY HOT DURING BAKING.
Ensure that the Breville Baker’s Oven is
switched off and then unplugged from the
power outlet when not in use and before
cleaning.
Do not immerse the bread pan in water. Doing
so may interfere with the free movement of the
shaft. Wash only the interior of the bread pan.
Do not leave the lid standing open for extended
periods of time.
Fully unwind the power cord before use.
Do not let the power cord hang over the edge of
a bench or table, touch hot surfaces or become
knotted.
To protect against electric shock, do not
immerse power cord, power plug or appliance
in water.
The appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instruction concerning
the use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
It is recommended to inspect the appliance
regularly. Do not use the appliance if the
power cord, power plug or appliance becomes
damaged in any way. Return the entire
appliance to the nearest authorised Breville
Service Centre for examination and/or repair.
Any maintenance, other than cleaning, should
be performed at an authorised Breville Service
Centre.
This appliance is for household use only. Do not
use this appliance for anything other than its
intended use. Do not use in moving vehicles or
boats. Do not use outdoors. Misuse may cause
injury.
The installation of a residual current device
(safety switch) is recommended to provide
additional safety protection when using
electrical appliances. It is advisable that a
safety switch with a rated residual operating
current not exceeding 30mA be installed in the
electrical circuit supplying the appliance. See
your electrician for professional advice.