Filter
Top Products
35
OPERATING THE BLENDER
PULSE setting
• For ingredients that require short
bursts of power, such as thick or coarse
mixtures, select the PULSE setting.
Rotate the START | OFF button to the
PULSE setting. Press the START | OFF
button each time you want to pulse
the mixture.
• To stop blending at any time, press the
START | OFF button. Lower the Safety
Locking Arm and ensure the blades have
completely stopped before removing the
Blender Jug from the Motor Base.
NOTE
If necessary, turn the Blender off and
ensure the blades have completely
stopped before using a plastic spatula
to occasionally stir or scrape down the
sides of the Blender Jug. Replace the
Lid before recommencing blending.
Do not use metal utensils as these may
damage the blades or Blender Jug.
8. After each use, remove the Blade
Assembly with the Silicon Gasket
still in place, from the Blender Jug.
Disassemble the Silicon Gasket from the
Blade Assembly. Wash the Blender Jug,
Lid, Inner Lid, Removable Silicon Gasket
and Removable Blade in warm soapy
water or in the dishwasher (see Cleaning
the Blender, page 39). Alternatively,
immediately fill the Blender Jug halfway
with warm (not hot) water and add 1-2
drops of dishwashing liquid. Place the
Blender Jug on the Motor Base. Select
speed 1/MIX and run the Blender for
10-20 seconds. Remove the Blender
Jug and discard the contents. Rinse the
Blender Jug with warm water until clean.
6. Push the START | OFF button. If
necessary, the 1oz (30ml) Inner Lid can
be used to measure and add ingredients
while blending. Remove the Inner Lid
and add ingredients while on speeds
1/MIX, 2/CHOP or 3/BLEND. When
operating at higher speeds; with a
Blender Jug filled at or near the ‘MAX’
line; or with hot contents; stop the
Blender before adding ingredients.
NOTE
If speed 1-5 is selected, the Blender
will automatically stop blending after
60 seconds. This is a safety feature
and prevents over-processing. If
necessary, restart the Blender by
pushing the START | OFF button.
In addition to the 5 speed settings, the
Blender features 3 additional settings:
SMOOTHIE and ICE settings
• These are pre-programmed cycles which
automatically adjust the blending times
and speeds to optimize blending results.
Rotate the START | OFF button to the
SMOOTHIE or ICE setting then push
to start. The pre-programmed cycle will
commence then automatically switch
off. You may notice the blending speed
change mid-cycle, this is normal.
• Process up to one standard ice cube
tray or 12-14 standard ice cubes at one
time. The type of ice used will affect the
consistency of the crushed ice. To create
even, powdery snow for icy drinks and
cocktails, use the ICE setting and large,
solid, dry ice that has come straight from
the freezer (22ºF / -5.6ºC, or below).
Small, slightly melted or hollow ice may
result in a coarser ice, perfect for use as a
base for fresh oysters.
BJB840XL_IB_D10_FA.indd 35 16/08/10 10:02 AM