Filter
Top Products
44
BLENDER TROUBLESHOOTING
PROBLEM EASY SOLUTION
Blender will not work or
suddenly switches off
during blending
• Check that the power plug is securely inserted into
wall outlet.
• Insert the power plug into an independent outlet.
• Insert the power plug into a different outlet.
• Reset the circuit breaker if necessary.
• Ensure the indicator on the START | OFF button is
aligned directly with the desired speed. The blender
may slow down and automatically stop if the indictor
is incorrectly aligned.
• Ensure the Safety Locking Arm is in the upright
position and is securely locked into the two grooves
on either side of the Blender Jug base (see page 32).
• The Overload Protection may have automatically
de-activated the motor. Unplug the power cord from
the wall outlet and press the OVERLOAD RESET
button found on the underside of the Motor Base.
This will reset the Overload Protection, enabling you
to reconnect the power cord to the wall outlet and
recommence normal use (see page 36).
• The Overheat Protection may have automatically
de-activated the motor. Unplug the power cord from
the wall outlet and allow the appliance to cool for at
least 15 minutes. Insufficient cooling time may result
in the motor de-activating again. After sufficient
cooling time, reconnect the power cord to the wall
outlet and recommence normal use (see page 36).
• The Electronic Protection may have automatically
de-activated the motor. Unplug the power cord
from the wall outlet. Either too much food is being
blended at one time or the pieces are not small
enough. Try removing a portion of the mixture,
cutting food into smaller pieces of even size and/
or processing a smaller amount per batch. For best
results the food should be chopped into pieces no
larger than 3/4 inch (2cm). Then reconnect the
power cord to the wall outlet and recommence
normal use (see page 36).
BJB840XL_IB_D10_FA.indd 44 16/08/10 10:02 AM