Filter
Top Products
SUPREMA 2001 - OPERATION & SERVICE MANUAL
Suprema 2001 - Operation & Service July 6, 2001 Page 17 of 60
Reminder: The “
INCREASE
” (+) and “
DECREASE
” (-) buttons are located to the right of the “
START
”
button, and the “
MENU SCROLL UP
” and “
MENU SCROLL DOWN
” buttons are located to the
left of the “
START
” button. See page 4 for illustration.
PRODUCT ON/OFF
This feature allows you to run a complete coffee or hot chocolate cycle (including the
two pauses) without any product being dispensed (no coffee or chocolate). This will
allow you to manually test brew different coffee blends for the customer to taste. The
customer can then decide which blend he prefers. To use it as a test brew cycle, simply
weigh and manually pour the coffee grounds into the brew chamber, and press the
"
START
" button. This procedure can be repeated if you need to test brew another blend.
1. To switch the product
OFF
, press the "
UP
" button on the hidden menu
scroll buttons and scroll until the following message appears,
a) Press the "START" button to enter set mode.
b) Switch the product "OFF" or "ON" by using the hidden setting adjustment
buttons. Press the "
UP" button to toggle it "OFF" or "ON".
c) To exit the "PRODUCT on-off" mode and proceed to the next setting,
press the hidden "
UP" or "DOWN" scroll buttons.
SETTING PRODUCTS
1. To adjust product settings, press the "
UP
" button on the hidden menu
scroll buttons and scroll until the following message appears,
a) Press the "
START" button to enter the set mode.
b) At this point, you can now select the product settings for any cup size,
product and product strength by pressing the appropriate buttons on the
selection panel. The time setting displayed will correspond to the LED's
that are illuminated.
c) Using the hidden setting adjustment buttons, increase or decrease the
timing for the product.
d) To exit the "SET PRODUCT" mode and proceed to the next setting, press
the hidden "
UP
" or "
DOWN
" scroll buttons.
PRODUCT ON/OFF
PRESS <START>
SET PRODUCT
PRESS <START>
!
Note:
If the product is
switched “
OFF
”, it
remains off until
you enter the “
SET
-
UP
” mode to
switch it “
ON
”
again. Please
make sure it is
switched “
ON
”
before you leave
the account.
!
Note:
The minimum
allowable setting
for all products is
0.5 seconds, and
the maximum is
8.0 seconds.
$
Tip:
While in the “
SET
PRODUCT
” or “
SET
WATER
” menus, you
can test the product
and water quantities
by pressing the
“
START
” button. The
product or water
tested will
correspond to the
LED’s illuminated
on the front
selection panel.
Make certain you
have something
ready to catch the
coffee grounds or
water that will be
dispensed.