Filter
Top Products
SUPREMA 2001 - OPERATION & SERVICE MANUAL
Page 20 of 60 July 6, 2001 Suprema 2001 - Operation & Service
SETTING THE DEFAULT
1. To program the default settings, press the "
UP
" button on the hidden
menu scroll buttons and scroll until the following message appears,
a) Press the "START" button to enter the set mode.
b) The LED's that correspond to the current default setting will now be
illuminated.
c) To change the default, press the buttons on the selection panel for the
new default settings. The LED's that are illuminated will now become
the new default settings.
d) In no default is set, the LED’s on the selection panel will light and scroll
until the user selects one. This applies for the products, strengths, and
cup sizes, therefore three selections will be required by the user.
e) To exit the "
SET DEFAULT
" mode and proceed to the next setting, press
the "
UP" or "DOWN" scroll buttons.
SETTING TOP PAUSE
The “TOP PAUSE” occurs when the brewer is at top dead center, and is before the
regular pause. When the piston reaches top dead center in the cylinder, the brewer will
pause for the amount of time set in this menu, to allow the coffee and water to steep
(mix together). The higher the "
TOP PAUSE" is set to, the stronger the cup of coffee that
is brewed by the equipment.
1. To set the "
TOP PAUSE
" setting, press the "
UP
" button on the hidden menu
scroll buttons and scroll until the following message appears,
a) Press the "
START" button to enter the set mode.
b) At this point, select the cup size by pressing the appropriate buttons on
the selection panel. The "
TOP PAUSE" setting displayed will correspond
to the cup size that is illuminated.
c) Using the hidden setting adjustment buttons, increase or decrease the
timing for the "
TOP PAUSE
".
d) To exit the "SET TOP PAUSE" mode and proceed to the next setting, press
the "
UP
" or "
DOWN
" scroll buttons.
SET DEFAULT
PRESS <START>
SET TOP PAUSE
PRESS <START>
!
Note:
The minimum
setting for the
“
TOP PAUSE
” is 2.0
seconds.