Filter
Top Products
SUPREMA 2001 - OPERATION & SERVICE MANUAL
Page 8 of 60 July 6, 2001 Suprema 2001 - Operation & Service
INSTALLING THE CARAFE TRAY, CUP STAND AND GRAPHICS BEZEL
10. Install the carafe tray, cup stand and graphics bezel.
a) Install the carafe tray as illustrated below. Once done, install the cup stand
on top of the carafe tray.
b) Install the bezel by first inserting the tabs on bottom if it into the notches
on the door. Push the top of the bezel into the door until it clips in place.
WATER CONNECTION
11. Connect the water supply to the coffee maker.
a) Apply Teflon tape to a 3/8" plumbing fitting. If a 1/4" line is being used,
you will then need a 1/4 x 3/8" fitting.
♦ Teflon tape should be applied in a clockwise
direction, going with the threads when tightening.
b) Thread the fitting into the inlet valve at the back of the
coffee maker and tighten with a wrench.
d) Connect the water line to the fitting.
e) Turn the water on at the source.
f) Plug the coffee maker into the wall outlet.
12. Switch the coffee maker "ON".
a) The main power switch is found on the back of the coffee maker.
b) When the power is switched "
ON", you should hear the coffee maker
filling with water.
c) Check the plumbing for leaks and correct them, if necessary.
d) Check the display for any messages, and take the indicated action.
13. Fill the ingredient dispenser with coffee.
a) Open the front door of the coffee maker.
b) Lift the lid on top of the coffee maker.
c) One section of the ingredient dispenser is larger than the other. The large
section is for the coffee that is expected to have higher consumption. The
smaller is for decaffeinated or lower consumption blends.
d) Fill the ingredient dispensers by pouring coffee through the opening in the
lid.
!
Note:
For initial water
connection at your
shop, we
recommend using
1/4" polytubing,
and an instant
(quick connect)
fitting. This will
simplify water
hook-up. For field
installation, we
recommend
copper tubing
from the source,
all the way to the
coffee maker.
◄
Install the carafe tray
(and grill) and the cup
stand (and grill).
►
Install the pre-
assembled graphics
(and pricing) bezel.