Filter
Top Products
SUPREMA 2001 - OPERATION & SERVICE MANUAL
Suprema 2001 - Operation & Service July 6, 2001 Page 43 of 60
REMOVING THE BREWER MOTOR
1. Remove the brewer.
2. Remove the brewer bracket.
a) Loosen, but do not remove, the two top screws from the left side of the
brewer bracket.
b) Remove the center screw from the left side of the brewer bracket (this
screw may not be used on certain types of brewer brackets).
c) Lift the bracket clear of the mounting "joggle" and pull forward.
d) Disconnect the brewer harness from the rear board.
3. Remove the two lower screws attaching the motor to the bracket.
a) These screws are located below the drive coupling.
4. Loosen the two upper screws.
5. Lift the motor and switch assembly up and clear of the key-hole slots.
6. Remove the switch assembly.
a) Remove the three screws that secure the bracket to the motor.
b) Disconnect the wires from the brewer motor.
INSTALLING THE BREWER MOTOR
1. Install the brewer motor onto the brewer bracket.
a) Align the two upper screws on the motor with the key-hole slots.
b) Install the two lower screws.
c) Tighten all four screws.
2. Re-connect the wires to the brewer motor.
a) Wires #8 and #9.
3. Re-install the brewer bracket assembly.
4. Replace the brewer.