Filter
Top Products
7-4
7-4: REPLACE TEMPERATURE PROBE (cont.)
6. Disconnect the wire harness containing the
probe wiring. It may be necessary to remove
the wire ties.
7. Use a pin-pusher to remove the probe wires
from the connector. Mark each wire for re-
assembly.
8. Remove the screw(s) securing the probe
bracket to the element.
9. Thread the probe wire through the hole in the
tilt plate assembly and remove the probe and
the securing components from the element.
10. Remove the probe from the probe bracket.
Place the new probe into the bracket.
Use a pin-pusher to remove probe wires from connector
Thread probe wire through hole in tilt
plate assembly, them remove probe and
components from element.