Filter
Top Products
23
2 Preparation
It is easy to permanently adjust the amount of water and milk for all
products to the cup size. Adjust the amount once as shown in the
following example. Every time you prepare a drink in the future, this
amount will be dispensed.
The permanent settings for adapting the amounts to the cup size
for all products follow this model.
Example:Proceed as follows to permanently set the amount of
water for one coffee.
Precondition:
‘Please select product:’ is displayed.
T Place a cup under the coffee spout.
T Press and hold the
‘Coffee’ button.
‘Coffee’ and the fill volume are displayed.
T Hold the
‘Coffee’ button down until ‘Enough coffee? Press
button.’
appears.
T Release the
‘Coffee’ button.
Preparation starts and the coffee flows into the cup.
T Press any button as soon as there is sufficient coffee in the
cup.
Preparation stops.
‘Saved’ appears briefly on the display. The
set amount of water for one coffee is permanently stored.
‘Please select product:’ appears on the display.
E You can alter this setting at any time by repeating the above
procedure.
E The amount can be permanently adjusted to the cup size for
the products shown in the product selector too. To do this,
press and hold the Rotary Switch k until
‘Enough coffee?
Press button.’
appears.
E You can also permanently set the amount for all specialty
coffees, milk and hot water in programming mode (see
Chapter 4 ‘Permanent settings in programming mode –
Product settings’).
Permanently setting
amounts for the cup size