Filter
Top Products
4
ENGLISH
3. Place the pasta ring (D) over the plate
and gently turn by hand until finger
tight but not over tightened.
4. Insert the cutter (B) into the socket,
aligning the flange with the left side of
the slot as shown. Push in until locked
into place and turn cutter to the right.
The pasta press is now ready to attach
to the stand mixer.
To Assemble Pasta Press Accessory
A multipurpose combo tool (L) with a
hook and wrench is provided. The flat end
may be used to help push dough into the
press. The wrench may be used to loosen
the pasta ring from the press body. The
hook may be used to pry the auger out of
the casing.
A storage case (E) is provided to store
pasta plates (F, G, H, I, J and K).
NOTE: Do not use combo tool to
tighten pasta ring.
RIGATONI
RIGATONI
FLANGE
TURN AFTER
INSERTING
INTO SOCKET