Filter
Top Products
10
EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide
Installing the DS-16M and DS-32M Rails
7. If you are installing the switch in a 39U cabinet, position the #10
washer and ball stud in the center hole, between the two
M5 x 12 mm screws. Hand-tighten the ball stud.
NOTE: The ball studs support the bezel.
If you are installing the switch in a 40U cabinet, use an M5 x 12 mm
screw to install the latch bracket in the center hole, over the
keyplate spacer. See the figure below.
8. Align the holes in the rear, u-shaped flange of the rail with the
holes in the rear inside channel.
EMC242
2
Latch
Bracket
Screw
Keyplate
Spacer
Rear (u-shaped)
flange