Filter
Top Products
EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide
9
Installing the DS-16M and DS-32M Rails
M5 x 16 mm flat head screws (see the table on page 3). Leave the
screws finger-tight, and tighten them after the switch is installed.
See the figure below.
If you are installing the switch in a 40U cabinet, install a keyplate spacer on
the outside of the channel as you secure the rail to the front channel. The
spacer is marked such that an L or an R will be upright when correctly
installed on the left or right channel. See the figure below.
DS-16M Round-Hole
DS-16M Square-Hole
Channel, Rack Front
Channel, Rack Front
(for example, the
(T
hird-Party Rack/Cabinet)
CLARiiON Rack/Cabinet)
EMC2424
Screw (2)
Spacer
S
witch
Mounting Rails