Filter
Top Products
EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide
15
Installing the DS-16M and DS-32M Rails
If you are installing the switch in a 40U cabinet, use the appropriate
screws to install the latch bracket (instead of the ball stud) to the
outside edge of the channel as you secure the rail. To attach the
bottom latch bracket screw, install an M5 clip nut over the
aligning hole in the channel. See the following figure.
7. Align two holes in the rear, u-shaped flange of the rail with two
holes in the rear inside channel.
DS-32M Round-Hole
DS-32M Square-Hole
Channel, Rack Front
Channel, Rack/Cabinet Front
S
tep 1
S
tep 2
EMC2421
Screw
(2)
2U Bracket
(Left)
Left Front
Switch
Mounting Rail
Screw
Left Front
Switch
Mounting Rail
Clip Nut