Filter
Top Products
EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide
21
Installing the DS-16M2 and DS-32M2 Switches
NOTE: There is a 3-inch space between the front of the switch and the back of
the bezel. This is enough room to loop the cord up without pushing the bezel
off.
12. When installing the DS-32M2 switch, the 2U spacing allows you
to run the power cords between the switches.
13. Secure the power cords in the retainer clips, and route them down
the trough along the edge of the rear of the rack. See the figures
below.
14. Plug the other end into available receptacles on the PDU.
Secure cords with
retainer clip
Run cables
down trough