Filter
Top Products
EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide
17
Installing the DS-16M2 and DS-32M2 Switches
Installing the DS-16M2 and DS-32M2 Switches
This section describes the procedures for installing the DS-16M2 and
DS-32M2 switches in a rack/cabinet, including attaching the brackets
on the switch. Both switches are installed in the rack/cabinet the
same way. Note, however, that the DS-16M should be positioned at
the top of the rack/cabinet, above the DS-32M.
Mounting Bracket Installation
NOTE: The mounting brackets are the same for both the DS-16M2 and
DS-32M2.
You must attach mounting brackets to the switch before installing it
on the rails. The mounting brackets slide into the C channel of the
rails.
Follow the steps below to attach the mounting brackets to the switch.
1. Orient the L-shaped end of the bracket upward and to the fan end
of the switch as shown in the figure below.
2. Place the bracket against the switch with the counter-sunk screw
holes facing outward. Align the five screw holes in the bracket
with the five screw holes on the side of the switch.
To guarantee that all the screw holes in the bracket orient correctly with
the screw holes in the switch, first align the bracket’s middle screw hole
with the middle screw hole in the switch.
At the fan end of the switch