Filter
Top Products
EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide
3
Switch Mounting Kit (DS-16M or DS-32M)
Switch Mounting Kit (DS-16M or DS-32M)
The DS16- and DS32-CRKH kits contain the16- or 32-port standard switch
rail mounting kits, and the DS16- and DS32-CRKL kits contain the 16- or
32-port low protrusion rail mounting kits.
Component Use
2 mounting brackets - see illustration on page 17. 2 per switch
2 short rail assemblies (20.5 inches to 27 inches)- see illustration on
page 6 or page 12
or
2 long rail assemblies (27 inches to 34 inches)- see illustration on
page 6 or page 12
2 per switch
#10 flat washer
M5 kep nut
2 per rail assembly to secure adjustable
rail to the “C” channel.
6-32 x .31 screws 5 thread-forming screws per bracket to
secure bracket to switch (10)
or
5 non thread-forming screws per
bracket to secure the bracket to the
switch (10)
Note: The kits include two (2) bags of
6-32 x .31 screws. Be sure to check the
labeling on the bags and the chassis
number label located on the back and
bottom of the chassis to ensure that you
use the correct screws for your chassis.
M5 x 12 mm screws 4 per rail for DS-16M in round-hole
channels (8)
3 per rail for DS-32M in round-hole
channels (6)
Square-hole washer
M5 x 16 mm screws
4 per rail for DS-16M in square-hole
channels (8)
3 per rail for DS-32M in square-hole
channels (6)
M3 x 8 mm screws 1 per bracket, used to secure brackets
to the rails (2)