Filter
Top Products
EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide
19
Installing the DS-16M2 and DS-32M2 Switches
5. Push the switch further into the rack/cabinet until the hole in the
front part of each bracket (the “L”-shaped end) aligns with the
hole on the fixed rail. See the figure below.
6. Tighten the front screws securing the rails to the front of the
rack/cabinet.
7. Secure the brackets to the rails with two M3 x 8 mm pan-head
screws (see the table on page 3), one on each side, as shown
below.
C channel
Align hole in bracket
with hole in the fixed rail