Filter
Top Products
EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide
11
Installing the DS-16M and DS-32M Rails
9. Secure the rail to a round-hole rear channel with 2 M5 x 12 mm
pan-head screws (see the table on page 3), or secure the rail to a
square-hole rear channel with 2 square-hole washers and
M5 x 16 mm flat-head screws (see the table on page 3). Leave the
screws finger-tight, and tighten them after the switch is installed.
See the figures below.
10. Repeat steps 1 through 9 for the other rail.
DS-16M Round-Hole
DS-16M Square-Hole
Channel, Rack Rear
Channel, Rack Rear
(for example,
(for example, Third Party
CLARiiON Rack/Cabinet)
Rack/Cabinet)