Filter
Top Products
18
EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide
Installing the DS-16M2 and DS-32M2 Switches
CAUTION
!
The kits include two (2) sets of screws. To avoid damaging the
screw holes, be sure to check the labeling on the bags and use the
appropriate set of screws for your chassis. The chassis product
number is located on labels at the back and on the bottom of the
chassis.
3. Secure the bracket with five 6-32 x .31 flat-head screws (see the
table on page 3). Tighten the screws fully.
4. Repeat steps 1 through 3 above for the other side of the switch.
Installing the Switch in the Rack/Cabinet
Follow the steps below to install the switch in the rack/cabinet.
1. Lift and orient the switch so that the fan end is to the front of the
rack/cabinet.
2. Align the bracket on each side of the switch with the C channel on
each fixed rail.
3. Push the switch about 3/4 of the way into the rack/cabinet.
4. Tighten the rear screws securing the rails to the rear of the
rack/cabinet.
Align middle hole first
Fan end of switch