Filter
Top Products
8
EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide
Installing the DS-16M and DS-32M Rails
3. Adjust the length of the rail to fit between the channels in the
rack/cabinet.
NOTE: The rail flanges go to the inside of the channels.
4. Once the rails are adjusted to the correct length, tighten the kep
nuts on the rail assembly.
NOTE: If the side skins are removed on the rack/cabinet, you can tighten
the kep nuts after you install the rails.
5. Align the holes of the front rail flange to the inside of the front
channel. The top and bottom screw holes are used for the screws;
the center screw hole is used for the ball stud or latch bracket.
6. Secure the rail to a round-hole channel with 2 M5 x 12 mm
pan-head screws (see the table on page 3), or secure the rail to a
square-hole channel with 2 square-hole washers and
"Top" up and to the
rack front
Flange to the inside
of the channel (rack front)