Filter
Top Products
16
EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide
Installing the DS-16M and DS-32M Rails
8. Secure the rail to a round-hole rear channel with two M5 x 12 mm
screws (see the table on page 3), or secure the rail to a square-hole
rear channel with two square-hole washers and M5 x 16 mm
screws (see the table on page 3). Leave the screws finger-tight,
and tighten them after the switch is installed. See the figure
below.
9. Repeat steps 1 through 8 for the other rail.
DS-32M
DS-32M Square-Hole
Round-Hole
Channel, Rear
Channel, Rear