Filter
Top Products
7.3 Cut-out for glass window (WFI
1061)
Fig. 23
(1) Overlay panel (3) Backer panel
(2) Spacer panel (4) Glassed area
The edges of the panels
Fig. 23 (1,2,3)
are visible at the
transition to the glass window
Fig. 23 (4)
. It can be covered
with a decorative molding
Fig. 24 (A)
for esthetic reasons.
Fig. 24
8 Changing the door hinges
You can reverse the door hinges, if necessary:
Make sure you have the following tools on hand:
q
Torx 25
q
Torx 15
q
Screwdriver
q
Cordless screwdriver, if necessary
q
Another person to help with the installation, if necessary
8.1
Remove soft stop mechanism (top)
Fig. 25
u
Open the door.
NOTICE
Risk of damage!
If the door seal is damaged the door may not close
properly and the level of cooling is insufficient.
u
Do not damage the door seal with the screwdriver!
u
Release panel
Fig. 25 (1)
using slotted screwdriver and
remove.
w
The panel hangs above the damper bracket.
Fig. 26
u
Push panel forward over the damper bracket
Fig. 26 (4)
in the direction of the appliance.
WARNING
Risk of injury if the soft stop mechanism contracts!
If the locking device is not fitted, the soft stop mechanism
contracts during disassembly and can jam your fingers.
u
Fit the locking device!
u
Engage locking device
Fig. 26 (2)
into place inside
oblong hole.
w
The locking device prevents the hinge from snapping
shut.
u
Unscrew cover that is on the hinge side
Fig. 26 (5)
until
the first notch using a screwdriver.
w
The bolt will become visible.
u
Push bolt
Fig. 26 (3)
out from below.
u
Press damper bracket
Fig. 26 (4)
in the direction of the
door.
Changing the door hinges
19