Filter
Top Products
Fig. 63
u
Glue spacer
Fig. 63 (72)
onto the lower part of the side
wall on the handle side, approximately 1.5 in. (40 mm)
as measured inwards from the front edge of the
appliance.
Fig. 64
u
Align the height of both appliances evenly using the
four roller bases. Use upper adjustment setting (1/4”)
Fig. 64 (70)
for the rear adjustable foot and lower
adjustment setting (1/4”)
Fig. 64 (71)
for the front
adjustable foot respectively. Turn clockwise to raise
and counterclockwise to lower. Maximum adjustable
height: 5/8 in (16 mm).
u
Position end strip
Fig. 61 (14)
over the installation
contour and align it such that the holes in ventilation
grille and installation contour are above each other.
u
Screw on upper installation contour
Fig. 61 (14)
through
the pre-cut holes using screws
Fig. 63 (15)
.
Fig. 65
u
Secure upperconnecting element
Fig. 65 (11)
using two
screws
Fig. 65 (12)
. Make preliminary holes (optional) or
use a cordless screwdriver.
u
Clip on cover panel
Fig. 65 (13)
.
u
Push appliances together at the bottom and realign if
necessary.
Fig. 66
u
Remove the spacers
Fig. 66 (20)
from the lower reverse
side of the appliances.
u
Position lower connecting piece
Fig. 66 (21)
such that
the screw holes are above each other and screw
Fig. 66 (23)
on from the side.
u
Position upper connecting piece
Fig. 66 (22)
and screw
Fig. 66 (23)
on from the side.
Fig. 67
u
Insert long carriage bolt
Fig. 67 (73)
.
u
Push washer
Fig. 67 (74)
and nut
Fig. 67 (75)
onto the
screw. Tighten nut until the spacer
Fig. 67 (72)
is
touching the opposite side wall.
u
Fit strip
Fig. 65 (16)
, push it slightly under the top cover
Fig. 65 (13)
and then press it downwards into the gap.
u
Tighten the screws
Fig. 66 (23)
.
Note
u
Depending on the recess height, you will need to install
a ventilation grille (80”), a ventilation grille (84”) or an
end strip. Observe the necessary ventilation cross-
sections (see 5) .
Fit upper ventilation grille (80” or 84”):
Side-by-side installation
30