NOTICE
Risk of thread damage!
u
Do not overtighten.
u
Connect the domestic water supply
Fig. 43 (5)
(e.g.
copper pipe) to the elbow connector
Fig. 43 (4)
.
Before fitting into the cabinet:
u
Check the whole water system for leaks.
Before using for the first time:
u
Have the water line bled (remove air) by a competent
professional.
NOTICE
Malfunction of the water intake!
If the water intake is shut off during operation but the
IceMaker remains in operation, the water intake pipe may
ice up.
u
Switch off the IceMaker if the water supply is
interrupted (e.g. holiday).
11 Anti-tip device
The screws for fastening the anti-tip device are not
supplied with the appliance. Appropriate screws must be
used for the material (wood, concrete, etc.) in which the
safety device is mounted.
WARNING
Risk of injury if the appliance tips over!
u
Install the anti-tip device to prevent the appliance from
tipping over when the fully loaded door is open.
Fig. 44
u
Mark the installation position for the anti-tip device on
the wall or back of the unit.
u
Install the anti-tip device
Fig. 44 (1)
using appropriate
screws
Fig. 44 (2)
.
12 Single unit installation
Kit 9900306 is required for the installation.
Fig. 45
The accessories kit 9900302 may be required depending
on the height of the recess. (see 4)
Fig. 46
u
Install anti-tipping device inside the recess (see 11) .
Fig. 47
u
Screw on upper installation contour
Fig. 47 (5)
through
the pre-cut holes using four screws
Fig. 47 (6)
.
Fit side installation strip:
Anti-tip device
25