Filter
Top Products
u
Completely raise the levelling wheels at the front and
back of the two center roller bases
Fig. 71 (50)
such that
the attached appliances are resting on the outer roller
bases only.
u
Align appliance inside the recess by adjusting the outer
roller bases
Fig. 71 (51)
and using a spirit level.
u
At the top and bottom of the recess check the gap A
between the front edge of the installation strip
Fig. 71 (3)
and the front edge of the side wall of the unit. It must be
1/2 ” (13 mm). Realign the appliance in the recess if
required.
u
Secure appliance inside the recess using three screws
Fig. 71 (52)
hinge side of each appliance. Do not scratch
the side installation strip
Fig. 71 (3)
when doing so.
u
Place cover caps
Fig. 71 (53)
over the screws.
u
Being careful not to affect the level, lower the levelling
wheels in the center roller bases
Fig. 71 (50)
until they
are resting on the floor.
Fig. 72
If a water filter is used:
u
Insert water filter (see 14) .*
If no water filter is used:
u
Fit lower ventilation grille
Fig. 71 (54)
flush with the floor
such that the rubber lip is at the top. It is held in place
via magnets.
u
Fit décor panels (see 7) .
Fit handles (framed panel):
Fig. 73
u
Push handles
Fig. 73 (60)
into the openings in the door
and screw on
Fig. 73 (61)
. Press cover trim
Fig. 73 (62)
into position.
Fit handles (overlay panel):
You can use either your own handles (that match the
kitchen cabinets) or handles from the manufacturer that
have been ordered separately.
Fig. 74 Handles from the manufacturer Ø 3/4” (18 mm)
Fig. 75 Handles from the manufacturer Ø 1” (25mm)
u
Fit handles to the overlay panel
Fig. 75 (63)
as shown in
the diagram.
Side-by-side installation
32